Users of Wide-Format Latex Technology
Dear Friends I was having print quality issues, so I decided to make sure the ink tubes didn't have air bubbles. I realized that the LIGHT CYAN and the LIGHT CYAN TUBES were filled with Air.. I have been successful in bleeding all…Continue
Started by Allie Hussein. Last reply by Shailesh Pandya Feb 13.
Replaced the carriage belt on the L25500. The old one snapped. Ordered an belt and tensioner for the printer (CQ869-67072) and installed it.In running the scan axis test, it reports scan axis length is short ( by approximately 3/8" ).In reviewing…Continue
Started by Mitch Dresner Sep 9, 2018.
My hpl26500 keeps telling me to reseat the ink cartridges?? what do i do!!??so far I've tries switching off the machine from the mains and trying againfactory settings from the menuwent in to service mode and then electrical systems, menu eerom…Continue
Started by soyeb ravat. Last reply by soyeb ravat Nov 18, 2017.
HPL26500 keeps asking to reseat the ink cartridges,So far I have tried the following :different cartridgesfactory settings from the menu on the machineWent in to service mode and then electrical systems menu, eerom reset and problem still…Continue
Started by soyeb ravat Sep 19, 2017.
Hello, since my ASUS A32-N82 battery is now completely wide, I am looking for a replacement. Although Google spits out several things really seriously not seem to me to some pages but.…Continue
Started by Cytheria Esme Sep 2, 2017.
You are disconnected from chat. Connect to join the chat.
Sign up to chat on HP Latex Users.
i have got a roll of material from hp and when i use the profile given for it, it still doesn't seem fully dry, i spoke to hp who gave me a new profile but its still not right, mainly blacks and dark colors are not fully dry, anyone got a profile that works for this material???
I'm having issues with my ink not curing on the left side of the printer if you are facing it. This problem occurs when doing banners and backlighted films. I can adjust my temps to fix the issue, but wondered why it does not cure evenly. It is always dark colors and on the left side of the print. Could my curing elements be bad?